Press "Enter" to skip to content

Step-by-Step Guide of Upgrading the Husqvarna FE 701 Headlight

Upgrading the headlight on your Husqvarna FE 701 can significantly enhance your night riding experience, improving both visibility and safety. Whether you’re looking to replace a faulty headlight or upgrade to a more powerful LED unit, this guide will walk you through the process.

Tools and Materials Needed

1. New headlight (LED recommended)
2. Screwdrivers (Phillips and flathead)
3. Socket wrench set
4. Electrical tape
5. Zip ties
6. User manual (for reference)

Step-by-Step Instructions

1. Prepare Your Workspace
Before you begin, ensure your motorcycle is on a stable surface and the engine is off. Disconnect the battery to prevent any electrical mishaps.

2. Remove the Existing Headlight
– Locate the screws or bolts securing the headlight assembly to the bike. These are typically found on the sides or the bottom of the headlight unit.
– Use a screwdriver or socket wrench to remove these fasteners. Be sure to keep them in a safe place as you’ll need them later.
– Carefully detach the headlight assembly from the bike. Disconnect the wiring harness from the back of the headlight.

3. Prepare the New Headlight
– If your new Husqvarna 701 headlight is an LED unit, check if it requires any additional components such as resistors or adapters. Most modern LED headlights are plug-and-play but refer to the manufacturer’s instructions.
– Connect the wiring harness to the new headlight. Ensure the connections are secure and covered with electrical tape to prevent moisture from causing a short circuit.

4. Install the New Headlight
– Position the new headlight assembly in place of the old one. Ensure it fits snugly within the headlight bracket.
– Secure the new headlight using the screws or bolts you removed earlier. Do not overtighten them as this could damage the headlight housing.
– Reconnect the battery and turn on the headlight to test its functionality. Ensure the high and low beams are working correctly.

5. Adjust the Headlight Beam
– With the new headlight installed, you may need to adjust the beam pattern to ensure optimal visibility.
– Park your bike on a level surface facing a wall or garage door about 25 feet away.
– Turn on the headlight and observe the beam pattern. Use the adjustment screws on the headlight assembly to align the beam so that it is centered and at the correct height. The top of the beam should be level with or slightly below the headlight height when viewed from the wall.

6. Finalize the Installation
– Once you’re satisfied with the headlight alignment, ensure all connections are secure and the headlight is firmly in place.
– Use zip ties to neatly organize and secure any loose wires, keeping them away from moving parts and heat sources.

Upgrading the headlight on your Husqvarna FE 701 is a relatively straightforward task that can be accomplished with basic tools and a bit of patience. The improved illumination provided by an upgraded headlight, especially an LED unit, will greatly enhance your night riding experience, providing better visibility and safety. Follow these steps carefully, and you’ll be back on the road with a brighter, more reliable headlight in no time.